Pause the print in your slicer or manually then add a magnet and a 1/2 inch steel ball. It's a weight shift so you can cast it farther.

magnet is .120" in height, .390" in diameter
Linky: https://a.co/d/8sdMq5j

Lure Volume is 82.48 g/cm3
wall count used is 4 walls, 40%infill. Which gives me around 49g in filament weight.
My total weight with hardware and everything is 73.61g.
Well below the volume so it float
pause at layer 89, which is around 1 hour 21min depending on your printer. My total print time is around 2 hours.

Youtube Shorts: https://youtube.com/shorts/thjYqQaM87o?feature=share

Thank you!