If you enjoy my designs please support my projects by buying me a drink and checkout my YouTube Channel @modellermark2 - thanks!
My Mavic Pro battery went bad - the "battery error cannot fly" meaning it just needed balancing properly but DJI considered it as scrap!
So i took it apart, added a balance lead to charge it properly then remixed a battery cover to make a new holder for the existing battery which has been perfect since.
Covered in more depth in this thread:
https://mavicpilots.com/threads/balance-plug-for-mavic-pack.34806/post-968025
It can also be seen in my video here: https://www.youtube.com/watch?v=ZW3JKGXS2kk

Pictures are of the original as i put it together so is a rough test print but eneded up being my permanent one as there was no point redoing it as it worked great even though not pretty.
But STL files uploaded have been updated with the tabs on the side built in for the clip and its corners tuned a little for a better fit.

Not perfect but might save you a load of cash if your battery does the same.

As always all done and used at your own risk - and be very careful when handling the LiHv cells.

Anet

A8

No

0.2

40%

I used a grey filaments to get close to the Mavic color

Remixed and redesigned using Tinkercad