A keychain of the shipping container shown in Tyler the Creator's Chromakopia album teaser. The keychain is quite small but is for the most part accurately scaled to the shipping container shown in the video. The keychain is meant to have fully closing doors however I made a mistake in the measurement before printing it. It has been fixed in the files uploaded and the doors should fully close. There is also a No Doors version for those that do not want doors!

Printing: The Keychain should be printed in 3-5 pieces. The trailer and doors are necessary but the dowels are a bit iffy. At the default scale most printers will struggle to accurately print the dowels, leaving them lumpy and not able to fit in the their designated hole. Personally I used some tiny metal rods and a small amount of tape over the top. I plan on replacing the tape with glue in the hole so it looks a little better.

UPDATE: apparently paper clips work perfect as a friction fit but still allow the doors to move around nicely. I tried coloring in the chromakopia font with sharpie cuz i don't have actual plastic paint and it looks ok if you dont look too closely.

My Print: Bambu Lab A1 Mini, Scaled to 110%, 0.16 quality, default settings but random Z seam and supports enabled(Tree and only touching buildplate). Kingroon 1.75mm PLA filament in green.

If you have any questions about the print or notice anything that needs to be changed please comment it! I have a larger scale version posted on my profile for those interested, it is different than just a scaled up version of this model so I would recommend checking it out.

UPDATE again: Someone asked for a version without the loop at the back of it so that has been added as an additional file. The loop deletion is the only change so doors and dowels are still compatible!