I'm sure you've wondered what the PS logo looks like from all the other angles besides the intended. So here's your chance.

This design is intended to be snap-fit. Print each part and put them together at ease.

Base

The base part is designed to be ironing-friendly. No more ugly streaks! Please slice this part at 0.16mm for the best outcome.

Filament Change

If you wish to do multi-color print, at 0.16mm layer height, insert a change at layer 48.

*If you can't do multi-color, use nail polish on the text instead and it shouldn't look half bad.

Support

Only the colored parts need support for better geometries.

Note

• You only need the rail and the colored parts to build the logo. The base is for a better and complete aesthetic and can be omitted.
• Please be prepared to use superglue, as the stumps on the base may snap off. Since this is only a stationary show piece, some glue shouldn't hurt anything ;)

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.16

Infill:

Filament: Generic PLA

Category: Video Games