I Printed a Greg Zumwalt complaint button II for my dentist that has a good sense of humor. Did some customization with dental tools. Maybe someone will have some use of them in some project.

I had very limited space for the tools. I rendered the dental pick too small and printing it at 2x in the slicer fixed that. I only printed the drill once. I printed it standing up with no supports. If I was to do it again at this scale I would likely make the main handle thinner. The bit I printed laying down at .10 layer height... it took twice to get a usable one. The pick printed with supports at the ends.

I printed this tooth at 2% of its size
https://www.thingiverse.com/thing:1485531

The project is here:
https://www.instructables.com/Complaint-Button-II-Hammer-Time/

I generated the text for the sides of the project with this routine https://www.prusaprinters.org/prints/71776-3d-text-on-a-breakaway-bar 

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Rafts:

No

Supports: 

Yes

Resolution:

.2 layer height with a .4 mm nozzle

Infill: 

20

Filament:

Geeetech PLA Silk Silver PLA 
 

Notes: 

SILK Silver may not be the best for detail but it does have some shine.

No support upright on the drill
support from plate for the pick at the ends only
support from plate for the dental drill printed laying down.

Category: Sculptures