After you put the cookies in, when you press the button, only one cookie will fall out. The assembly method is as follows:

1️⃣ Insert the sliding door

1. 将The subject is standing upright
2. Find it on the feed hopperA slender groove
3. 将Sliding doorSlide into the groove
   • Round holeIt should be aligned with the feed hopper
   • The flat side is facing downwards
4. Gently push it back and forth
   ✅ It should slide smoothly

If it feels too tight: Gently sand the edges of the sliding door.

2️⃣ Installation button

1. Find the one on the sideRound hole
2. From the outsideButton rodPush it into the hole
3. Inside the main body, the buttons should beContact the slider tabs
4. Press the button
   👉 The slider should move

No glue is needed - it uses a friction fit.

3️⃣ Add a spring

You haveTwo options：

🔹 Option A: Metal spring

1. Place the spring inside the main body.Behind the button
2. One end contacts the button
3. The other end is pressed against the inner wall
4. Press the button → It should bounce back

🔹 Option B: Printing springs

• Slide inSpring channel
• The principle is the same: press the button to activate it, and the spring will push it back

4️⃣ Lock in place

• The slider has oneA small bump
• There is one main bodyA matching slot
• When the button is released:
  ✅ You will hearA clicking sound
  ✅ This means it's aligned and ready for the next cookie.

5️⃣ Install the hopper

1. Connect the hopper to the conveyor belt.an opening at the topAlign
2. Press it down hard
3. It should be on the feed troughFit into or align closely with

No screws are needed.

6️⃣ Add a cookie tray

1. 将TraySlide into or get caught in the bottom opening
2. Make sure it is located directly below the exit hole.
3. Try throwing a cookie with your hand