A dragon created by AI. 

Yes, a dragon. What can I say? My childhood was completely taken over by D&D.
I wanted to see if I could generate some acceptable drawings to later convert them into Hueforge plates, and I actually managed to get a few. This is one of them, and you can find more on my profile.
ragon escupiendo fuego.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used:

    PLA Smarfill Black 
    PLA Smarfill Red 
    PLA Smarfill Yellow 
    PLA Smarfill White

This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Red
    At layer #13 (1.12mm) swap to Yellow
    At layer #20 (1.68mm) swap to White for the rest