Tile leveling system clip, 1.5mm

The model has been tested during the actual tile installation process - it functions perfectly and meets expectations.

What's important is toSide-on printing... to prevent the clips from cracking when inserting the wedge-shaped pieces!

The bottom of the model contains small grooves, which make it easier to break it off after the adhesive has solidified.
It is recommended to usePETG printingBecause it offers better durability.
It can also be printed with PLA, but it might be more brittle.

Dimensions: 32 × 29 × 37 mm
Grouting width: 1.5mm

Wedge-shaped groove: 25 x 17.8 mm

Recommended settings

• 0.2 mm layer height
• Fill: 15% grid
• Support: Tree-like
• Skirt hem: only the outer part *What's important is that the model won't come loose during the printing process.
  
  Draw the support as shown in the following figure.