Hello everyone

This time, it's a bust of the Sailor Moon character.

The printing effect is very good, but there are many details and the parts are very fine, so you need to be careful when removing the support structure.
It is recommended to use marble-colored or gold PLA for printing.

The printing parameters are as follows:
- Floor height: 0.16
- The initial floor height is 0.2
- Align and sew.
- The border is 3 pixels wide.
- The filling rate is 15%, and a gyroscope-shaped pattern is used.
- A tree-like organic support structure. In this example, I slightly increased the distance between the top and bottom
If you have any questions, please raise them in the comments section.

A tribute.