A Waveshare Zero-DISP-7A display case that allows for the button control on top and access to the sdcard slot on the Raspberry Pi Zero(2) and access to the Power, eth, USB and audio out ports of the display. Mount points for speakers along the bottom edge.

You also have access to the mount points on the display to allow you to attach a stand or hang it like a picture frame on a wall etc.

The inserts are M3, d=5mm, h=4mm.

EDIT 20240825: Extended the length for the button board.

EDIT 20240805: I was made aware that the mounting holes were not always aligning properly.

I have gotten in touch with Waveshare and they have informed me that the boards are manually attached so there will be slight variances on board placement.

New model updated with bigger holes and a slot in the mounts to allow for a washer.

If you have already printed the model, you'll just need to print new stands and drill the center holes to 5mm. I think that should be enough. If not, please let me know.

EDIT 20240624: Added Mount points for speakers. I used these ones from AliExpress as I couldn't find ones with a grove connector that were suitable for the job. I've included a mock connector that you can use to aid installation. Pop off the default connectors using a pin and then I found gluing them into place on the mock connector helped.

EDIT 20240607: Added new battery stands for powerbanks.

EDIT 20251117: Added Picture frame hanger stand.

EDIT 20251118: Added Vertical stand. Door will need to be left off for the time being for the cable to pass through. It has only had basic testing but seems to do the job.