This is a hidden hinge. It can open 180 degrees and has a gap radius of 14mm, so it's suitable for panels up to 14mm thick. I'm using it to make a 12-mm-thick plywood box. It's a 3D-printed model. The tolerance is about 0.3mm. Usually during printing, the part with the slider on the top will move but stay stuck. You need to shake it a bit to loosen it. When you push it to loosen it, make sure to apply force along the groove. After all the parts

Although it may seem simple, this is not an easy print. If the tolerances are not increased, the parts will be too loose after completion, and there will be significant and complex overlaps between the sliders and the grooves. Before attempting this, please ensure that your printer has been calibrated and is operating accurately.

Printing configuration

Printing brand:

Prusa

Printers:

i3 MK3

Raft layer:

None

Support:

None

Resolution:

0.1 - 0.2

Fill in:

A lot of

Explanation:

This is a structural part. I used 3 layers and 20% infill