This is a remix of DANO83 design i just adjusted the sma hole so it would fit a tbs sma connector, added a place to hold some wires, added a slot at the bottom of the vtx mount so you can zip tie to closer to the side or if you use different equipment there , and added a reinforcement to the thumb screw mount just to give it a little extra strength.

Doesn't Matter

Yes

.2

20

i have printed this in its generic form and found that a support touching the build plate would have worked better since the zip tie slot on the back needs a little piece to hold it during print also found that it was rather flimsy at my print settings i am sure by increasing the infil it would have been fine still very strong thought.