Attention! Don't do that at all!No action has been takenClose the box when you're done! Otherwise,It's so hard to open it again!

This is a simple medicine box that can be custom-made to produce any packaging box you want.

This is the outer packaging of the Hatsune Miku sustained-release tablets that has already been designed. If you want to design your own outer packaging style, you can refer to the following picture for design inspiration, or design it by measuring the actual printed model.

(For entertainment purposes only!)

Production process:

0. Prepare other parts that are not included in the design

1. Print the shell and get the main body of the model

2. Cutting self-adhesive stickers

3. Stick the self-adhesive stickers on the main body of the model according to the finished product drawing

4. Use adhesive tape to waterproof the model: The specific steps are as follows:

Brief description in words:

Figure 1: Use tape 1~3 to stick the front and long sides. Tape 1 and 2 are stuck on the left and right sides, and tape 3 is stuck in the middle. After sticking the tape on the front, fold the remaining length along a straight line, continue to wrap the short side, and finally put the tape head back into the box.

Figure 2: Stick the tape vertically on the short side, and cut the tape until its length is the same as the short side. Then, fold the excess tape ends inward.

Figure 3: Use tape 1 and 2 to stick the back and short sides of theTape 3 is particularly important!

First, fold a small part of the tape head inward to form a non-sticky area. Then pull out a bit of tape and stick it on the back, winding it around the inside of the box to the other side. After confirming the length, cut it off. Similarly, fold a small part of the tape head inward.

In the end, the finished tape 3 is partly sticky and partly not sticky.This is an important part of pulling out the box.

5. Put the printed instructions and the candies into a small box, close the box, and you're done.