This model is designed for a Guitar player that wants to sing as well. It holds a standard Microphone on the Guitar Strap, so no need for a separate guitar stand, or some one to hold it!

Cam Lock Print in Place for Straps (V2)

Redesigned the strap holder above to accommodate microphone and stretch it to 50mm for guitar strap.

Needs in addition to the 3D model.

Two panel pins 1.60 diameter x30mm long

5M (5mm diameter) bolt, nut and 3 washers

The pictures show the assembly, put the bolt through the base plate and microphone holder putting a washer under screw, in between two 3d parts and under nut. Loosely assemble so it can be tightened later and can be adjusted when required.

Mount the base on the guitar strap with the microphone facing away from the player.

Mount the snap fastener to the base.

The two pins go in the side base and  the snap fastener holes to act as a pivot.

All Done. The microphone slips into the round holder as shown in the pictures.