This Raspberry Pi Camera module case is part of the Raspberry Pi-based open-source data collection project. More information can be found at the Github Repository link below:

https://github.com/hleve/rpi_data_collection

This module is intended to act as a sensor module that connects to the main computing module through a ribbon cable. In its current state, this module is intended to be mounted to the brim of a hat and pointed towards the face. Version 1 of this model is for a single camera angled at 21 degrees to capture facial information for sentiment analysis. Version 2 uses a single camera and a double prism setup to capture facial and environmental information.

The Raspberry Pi Camera model can be found here:

https://www.printables.com/model/1043855-raspberry-pi-camera

The case for the Raspberry Pi Zero and Pi Sugar battery module can be found here:

https://www.printables.com/model/1046800-raspberry-pi-zero-and-pi-sugar-battery-case-open-d

This project can be printed in PLA, but for better UV resistance for outdoor use, ASA is the recommended material.