MakerTom's original design proved unsuitable for my rainwater tank pump, which delivers lower water pressure than a mains supply. The original jet's range was approximately 1.5 meters. Consequently, I redesigned the jet for reduced flow rate, increased range, and broader lateral dispersion. Two versions are provided; the second features an even thinner jet with greater lateral dispersion. The gentle water stream is plant-friendly.

The original nozzle was also too short and difficult to remove from the hose connector, so I extended it to 65 mm.

Variants:

• Watering_jet_1 (narrower): jet 2 x 17 mm
• Watering_jet_2 (wider): jet 1 x 30 mm

Print with the jet tip on the build plate—the Gardena coupling facing upwards. Printing is straightforward with any filament; supports are unnecessary.

A rubber O-ring is required for sealing (16mm outer diameter, 2.5mm ring thickness).

If you appreciate the model, please like it. ❤

MakerTom's original model was entirely unsatisfactory for my purposes, as I use a rainwater tank pump for watering. This pump provides lower water pressure than a mains water supply. With the pump, the original nozzle had a range of approximately 1.5 meters. Therefore, I redesigned the entire nozzle to achieve a lower flow rate with a greater range and lateral dispersion. I created two variations, the second having an even thinner stream with increased lateral dispersion. The nozzle is gentle on plants due to its fine water distribution.

The original nozzle was also too short and difficult to remove from the hose connector; therefore I extended it to 65 mm.

Variants:

• Watering_jet_1 (narrower): nozzle 2 x 17 mm
• Watering_jet_2 (wider): nozzle 1 x 30 mm

Print with the nozzle tip on the build plate, Gardena coupling upwards. Simple to print using any filament type. No supports are required.

A rubber O-ring is needed for sealing (16mm outer diameter, 2.5mm ring thickness).

If you like the model, please like it.  ❤