Hello everyone.
This time it is a figure of Toothless, the dragon from the movie “How to Train Your Dragon”
I have manufactured it in PLA Marble so I don't have to paint it, but it would also look very good in black.

It is made with:
-Layer height 0.16
-Initial layer 0.2
-Aligned seam.
-Wall loops 3.
-15% infill with a gyroid pattern.
-Organic tree supports. In this case I have increased the upper and lower distance a little (0.18) so that the supports are not marked.
For any questions I am at your disposal in the comments.

Greetings.