Project: dragones y samurai 5 colores.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150.38x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
PLA smartfil negro Transmission Distance: 0.4
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA smatfil rojo Transmission Distance: 2.3
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA smatfil White Transmission Distance: 6
This print uses 5 unique filaments

Swap Instructions:
Start with negro
At layer #12 (1.04mm) swap to Blue Gray
At layer #16 (1.36mm) swap to rojo
At layer #19 (1.6mm) swap to Yellow
At layer #23 (1.92mm) swap to White for the rest.