I decided to make a keychain using the MakerWorld tool, as the existing designs were not entirely to my liking

I hope you like it and feel free to print it for your ventures at fairs or bazaars

1. I used the following settings
2. 10 layers or 2 mm in height with a 0.2mm layer height
3. 10% infill
4. 4 top and bottom layers
5. 11 keychains can fit on a Bambu Lab A1 plate
6. I reduced the print speed by 20% from the default in the slicer

I recommend flipping the design so that the colored part is smooth and has a better finish

I hope you like the design and can support by leaving a like and posting samples of your prints in the comments, that would help me bring more designs