This is a M6 adapter to fit a camcorder or camera onto a standard microphone 15mm screw stand.Use two appropriate washers for each side of horizontal bolt to prevent crushing the 3d print.I made this because i had a few mic stands lying around and thought it would be great to just attach the camcorder onto them leaving the stands in the other rooms i was recording.

Use a hex head 15-16mm m6 bolt head for the main shaft bolt that screws into the camcorder or camera or whatever.(I just cut down a 20mm one i had).Use an allen key M6 25mm bolt or similar for connecting the horizontal bolt...enjoy ;)

UPDATED V2:

• Thicker outer ring on the base section, original version was too thin.

Creality

Ender 3

No

No

0.1

30%

Any material does the trick.