GPS mount for the back of the drone / quad . Specialty of this mount is that it is straight, with no tilt. For setups where GPS with compass is used. For easy compass calibration in iNav. You will not need to customize compass tilt angle. However you will need to check and if needed alter the compass orientation.

Different variants available. With 4mm VTX antenna tube and with 5mm. With side accessory slots and without.

Designed around 25x25mm GPS module BZGNSS BZ-251 for my SpeedyBee Mario 8 Fold drone

Quad frame standoff diameter 4.8mm
Standoff spacing 26mm
Standoff height 22mm

ZIP tie slot is 3x1.5 mm so I would recommend ZIP width of 2.5mm and even better would be 1.9-2.2mm width to match flexibility and scale.

I used TPU with 64D hardness which I would call semi flexible
0.2 resolution
2 walls
15% infill
Build plate only supports

Creality

K1

No

Yes

0.2

15%

TPU