Remix of my previous celtic spinner, using 8mm bearing balls for weight instead of nuts.

Can print without supports if you use 0.2mm layer height or finer.

Print two of the CelticSpinnerBalls.stl, instert a 608 bearing in the center of one, and place twelve 8mm steel bearing balls in the divots. Press the second half of the spinner onto the 608 bearing and the the ballast balls should be captive. On my printer this was a friction-fit on the bearing, so I did not have to glue the two halves together, but you certainly can!

Also added caps for the spinner to make it easier to hold. Three different designs:

• Plain
• Triskelion
• Celtic Tree of Life

For the two with graphics, you can achieve a two-tone effect by printing at 0.2mm layer height and changing filament after the second layer. Supports not required.

TEVO

Tarantula

No

No

0.2mm

20%