Print in place hinged vat cover, printable on the Halot One itself.

I've included cxdlp so you don't need to slice it again... just load the cxdlp straight onto the printer. This is 5% oversize in all dimensions, because my first print shrunk by that much. If you're not getting that much shrinkage, you may want to scale it down a bit.

I did need to cut the screw slots deeper... just ground them away against a drill bit in a drill press. Some-one may want to modify the design for that. Or I may do... it's currently a bit fiddly getting it into place.

Creality

LD-001

No

Yes

.050 height is fine

There's a .5 mm gap between parts, which works fine. .2mm is too small.

It's a 9 hour print because of the height.

The 2 parts should be separate. If not ease them apart with a scalpel or razor blade.

I designed this based on https://www.thingiverse.com/thing:5277874 but really started from the ground up.

I use OnShape.com for my design work, and you can find my design at https://cad.onshape.com/documents/4dc9d5a0baed71909fb0590f/w/9d1c97abe83db2a9bf5c6150/e/180d667bf18afcd894e93bfe or search the Public spaces for "Halot One Vat Cover"