This is a vertical enclosure in two parts designed to hold an Electric Imp device and environmental sensor board while providing enough open air space to get accurate readings. The bottom and top are both threaded and should screw together for a friction fit. The whole thing is designed to hang outside in a sheltered location where the board inside can take temperature, humidity, and other atmospheric measurements.

Two different bottom parts are included which only differ aesthetically. I have included the V1 parts for the record, but they proved to be unreliable in keeping rain out of the enclosures in wet weather.

Printrbot

Simple White

No

Yes

0.2 mm

15%

I typically print these in either PLA or PETG, oriented vertically on the build plate. The bottom pieces need supports to hold up the triangle flanges, but the top prints fine with no supports at all.

Hang the enclosure outside in a sheltered location. Ideally it should be (mostly) free from direct sunshine or rain.