These are my files for my Cetme Model L project I was working on quite awhile ago, It heavily needs some reworks on various parts, the front end where the pin goes prevents a hop up from being installed, the handguard could use some strengthening, gearbox fitting needs adjusted and etc

The project currently uses a V2 Gearbox and a V2 Hopup, uses a m4 style mag catch, and the upper/lower are set up to accept a surplus Cetme stock

The project would benefit from some internal reworks, threads being redone cause they are very weak at the moment, a v3 gearbox may work slightly better especially with widening of the receiver but as my printer is down and I have not been 3d modeling for almost a year I'm leaving the project up to people to continue if y'all like to.

All files in a stl format

Creality

CR-10

Yes

Yes

40%-60%

Print to the settings that make you most comfortable with the strength of the model, when I initially printed my files, my printer was junked up and it still came out very sturdy but print it to whatever settings you prefer.