I was using j0anycubic's design (https://www.thingiverse.com/thing:4506909) but I didn't like where the build plate was sitting when angled.

This is my take on the design, built from scratch so the build plate sit closer to the position it is when using the original bracket provided with the Elegoo Mars. Allows for taller prints to be left dangling.

This design uses M3 bolts and nuts, but 4-40 should fit. Let us know in the comments if you try.

Prusa

I3 MK3S

No

No

Printed in PLA, no support if your bridging is not too bad.