Summary

I designed these knobs as a cosmetic upgrade to replace the original ones that I have
design a few months ago due to its size and it appears kind of bulky but it is reliable
and will remain as an option. The purpose of this new design is to make the knobs a
bit smaller at a reasonable size and also make it more unique. And also help make it
easier to identify the RC vehicle from everyone else's if that rc vehicle is with its
owner at the track. And because I can do so. If you wish to download these files you
will need about four screws for the base they need to be 3x30mm And the photos should
show you how to install the 3D printed body mounts.

As for the knobs themselves you will need 4 stop nuts they need to be 3mm also
Depending upon your 3D printer and how you print the parts themselves you will need
a dremel power tool with a special bit as you see in the photos and a exacto knife
And also depending upon your vision you will need a loupe that Jewelers & watchmakers
use to magnify your vision so you can see what you're doing As you clean up the area
where the stock not will go. And also you will need four Traxxas Foam Body Washers part
no.4915 or something similar to this to put on the body of the RC vehicle to provide
some friction for the knobs themselves so they would not damage the body of the
RC vehicle. After that the photos should give you an idea how to assemble it I apologize
for the blur photos but you should get the idea how to install it. After that the
photos should give you an idea of the end product so enjoy this upgrade.