This is a file that I made for an art piece called 'A Scanner Darkly', where these fake security cameras read off text via spotlights inside the body of the security camera.

Take em, make em, show me how they're remixed!

These pieces were made to be easily printable, assemble by slot together, and the provided .step file should allow you to easily modify it to allow for wire pass-through. If your prints are watertight, the lid should provide a good measure of protection from the weather as well. In addition, there's a recess in the window at the front of the lid to attach a piece of acrylic.

Prusa

i3 MK3

No

No

• x1 - 1/4-20 Hex bolt - at least 3/4" long
• x1 - 1/4-20 nut
• x1 - 1/4 washer
• x1 - m5 x 35mm+ flathead screw
• x1 - m5 hex nut

You'll need a 1/4-20 hex bolt to slot into the pan-tilt bracket, along with a nut and a washer.
I used a 1/4-20 x 3/4" bold with a washer and an acorn nut to give the piece a finished look.

Also sorry / not sorry for mixing metric and imperial. Chaos reigns.