Round leg extension parameters:

• height (default 20mm) – by how much you want to prolong the leg

• depth (default 20mm) – how deep the leg will sit inside the extension

• innerDiameter (default 20mm) – diameter of the leg

• tolerance (default 0.2mm) – tolerance to easily fit the leg into the extension

• wallThickness (default 5mm) – thickness of the extension around the leg

 Rectangular leg extension uses the same parameters as above, only instead of innerDiameter following two parameters define the rectangle size:

• rectangleSideA (default 30mm)

• rectangleSideB (default 40mm)

To modify the parameter values, open attached f3d file in Fusion360 and go to „Modify“ -> „Change Parameters“. Attached STL files use the default values listed above.

Increase infill to make them more sturdy.