Ryobi Water pump V2

My old pump burned up after leaving it on with no water flowing though it.
When I ordered another I got a smaller one so I designed a better case. The case is a remix from a Ryobi power supply.

The pump is a 12V-24V pump and works great with the 18V batteries, Search 12V or 24V solar water pump and look for one similar to that shown in my pictures. The model # of the pump I used is ZYW680 and it is about 41mm in dia.

The pump has a sliding bracket, in order for it to fit you have to cut one side of the bracket (you'll see what I mean when yo go to install it) and install it using only two screws through the lower holes.

Parts

1 ea water pump
1 ea 3d printed case
2 ea 8-32 x 1 inch screws
2 each 8-32 lock nuts
2 each small electronics screws (to mount battery terminals)
2 each battery spring terminals (search aaa battery spring contact plate)
2 each 22awg ring terminals
1 each mini rocker switch (2.1cm x 1.4cm x 2.5cm)
1 each 8" length of wire (I used 22AWG which is the same size the pump had)

The battery connectors have really small holes, I generally take a drill bit that will fit in the holes and use it in my drill to wallow out the hole. If you try to just drill a bigger hole its easy to bend it.

I printed mine in black PETG with 100% infill & supports and it printed really well. It used 136 grams of material.

Enjoy!