Hi,

this is my project for KCD2 Philips OneBlade contest.

The stl files should give you a gatehouse, as a place to store the Philips OneBlade and its accessories, in the Kingdom Come Deliverance II style.

My models were printed on Prusa CoreOne+. I recommend printing all models in 0.20mm STRUCTURAL settings. I also recommend using PLA or PETG filaments, I used both. I also recommend using 3DLAC or something similar on printbed for all models. I didn't use any supports or brim. But if you will have problems then use it.

Step by step manual:

1.      Print Gate_house – I used Fuzzy skin for exterior wall, but it isn't mandatory.

2.      Print Gate_inside – Snap model inside Gate_house. The bevel should point out of the gate.

3.      Print Gate_roof – Snap it on the top of Gate_house, orientation doesn't matter, front and back are symmetrical.

4.      Print Gate_gate – Orinent model on print bed so hexagon bit is pointing up. After printing the model, do not attach it to the Gate_house immediately, you will still need to add Gate_handle and Gate_symbol.

5.      Print Gate_handle – Print it so the wider end is on the print bed. The model will be attached to the hexagon on the Gate_gate. When you insert the model onto the hexagon on the Gate_gate, turn it to the side and when you feel resistance, let it go and it should hold, it is a good idea to add superglue to be sure.

6.      Print Gate_symbol – Print this model so the side that you read is on print bed if you have PEI sheet, it looks better. This model will fit into the grooves on the Gate_gate. It is necessary to use super glue to attach it.

Snap the Gate_gate on Gate_house and it's done