The instructions suggest using a box cutter to cut these blinds to width, but on a test cut I quickly found this would be difficult. Instead, I used a kitchenknife and this printed guide to make it easier to cut straight.

This was designed for a blade 1.4mm in width, but you can edit the parameters of the included Autodesk Fusion file if you'd like to accomodate a wider blade. the blind is about 18mm tall when stacked.

Tips for printing & using:

• Print in a rigid material like PLA

• This requires no supports, print on the angled end

• Insert the blind from the non-angled side, as a single bridging line may get caught.

• The offcut side should be the one with the label, as it tears the blind when removing it.

• When marking the blind for cutting, take note of which side of the line to cut.