These raise your speakers up 14cm, which is the perfect height for my desk. Inclulded are STL and Step files for all your remixing needs. You need one top, one bottom, one middle, one vertical connector, two short connectors, and 2 large connectors. I've connected all the parts using CA glue. One 3mf-file containing all files needed is included aswell.

Print parameters:
2-3 perimerters
10-15% infill

Non-printed hardware are 72x72mm foam pads for isolation, can't link mine as i had them in storage forever. Recess on the top is 75x130mm at the front and back for all your vibration isolation needs. On the bottom I've put 10x3mm round rubber feet.