This cable organizer is designed to fit the Modular Tablet Charging Stand I made here :

https://www.printables.com/model/1652233-remix-tablet-charging-stand-charger-block-600w-8-p

This model can also be used with the original version of the charging stand (link below), but for that version the addition of the SpacerLong module and additional ConnectPegs are also needed from the above link.

https://www.printables.com/model/61587-tablet-charging-stand

Assembly and Use

To add the organizer module to the already assembled stand, simply fir the two "legs" on the bottom of the organizer into the rectangular hole next to the charger (see photos). Note that the legs are angled outward very slightly, so as to provide a spring fit; you may need to pinch the legs together a bit to get an initial fit.

To add USB cable, with the organizer in place simply thread each cable back and forth through a slot in the organizer to take up any slack. I like to leave just enough cable protruding to be able to easily connect to a tablet.

Print Instructions

Print in PLA using the 3mf files provided, otherwise :

• 0.2mm layer height

• 2 perimeters

• no infill

• inner brim only 

  • In my experience, inner brims are easier to remove than outer brims

Note that the model should be oriented as shown in the photos, for printing.

CAD

The OnShape 3D CAD files for this are here :

https://cad.onshape.com/documents/2a1ff791d3cdb85b1586a289/w/671a06d370b51c1b80410d7c/e/2d1961d2e662f96e17c6283b?renderMode=0&uiState=69d7c3d2e73650ebde0214f3