Here is a super bedside lamp

Might be a nice present for the landlord of the local Biker pub

As it is a lamp I tried just 2 wall loops with zero infill.

As long as you have good bed adhesion 15% overhang using organic support should do the trick....

I tried using grid supports but then the printer tries to fill up the inside with thick supports and they are difficult to remove from the hole!

I have made a much more friendly fitting for the stand... the shade just sits on top...much easier to fit the light bulb...

I am just printing a new one with my colour printer... I shall add a picture when it is finished.... I have just added the colour printed model on the end of the other photos...(My camera  on my phone is not so good with colours...they are awesome.) if you do not have a multi colour printer it is not so bad cos the white model is fabulous!

this one took  21 hours with my ankermake m5c  and then 3.5 hours for the base...

(just one thing... dont use the old fashioned 80w light bulbs... they are much too hot and she will melt... use an LED type cool lamp.... I used an LED 8w type and it is really quite bright!