This was an item I made for a colleague. He was tired of the PAT stickers going missing, loosing stickers or even them getting ruined as there was no protective case.

Its split up into 2 parts, the pass stickers (Tall Bottom) and fail stickers (Small Bottom).

The Top piece should fit both bottoms as with my testing it did but I made the slot in piece slightly smaller then the bottom pieces slot in holes so for me the print was snug but snug enough that you could replace the stickers so you may depending on your print tolerance have to make the top part bigger or smaller to fit more snugly.

The bottoms feature a hole or slot to let the sticker fit through, I found snipping the top part of it with a pair of plyers makers it easier to replace an empty roll but I've kept it in there as it takes seconds to snip and you do you bud.

Infil: 20%