This is an image of Batman made with hueforge.

Here are the instructions for printing:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x195.49mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.5mm and the Actual Depth is 1.9mm

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Basic Blue Transmission Distance: 4
    PLA BambuLab Basic Gray Transmission Distance: 2
    PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #14 (1.2mm) swap to Blue
    At layer #19 (1.52mm) swap to Grey
    At layer #20 (1.68mm) swap to Jade White for the rest.

If you like this post, please consider boosting it, thank you: