I wanted something stylish and simple for my desk, but existing designs were either too small or complex prints, so I designed this!

• Rounded design reduces printer jerk, resulting in a clean print.
• Two sizes (13.5mm and 11.5mm) enables it to fit most phones (with cases!)
• Clearly marked sizes on the print, but clean look once device is inserted
• Optimised geometry for strength and balance while reducing material usage
• Deeper cutouts ensuring even heavier devices are held well (and can be used when docked without falling over!)

I've also uploaded the version without the marked sizes, if you wanted a truly clean look!

Print Settings

• 0.2mm layer height (I used "0.2mm speed")
• Infill 15%
• Material PLA, but others should work
• No support, no brim
• Print on it's side, as shown in .3mf file.

Design

Designed using SolidWorks. Original .SLDPRT model and .STEP model uploaded for easy remixes!