READ BEFORE YOU PRINT:

Mounting plate for MO-RA 420 that holds up to four 200mm fans.

Compatible with 200mm Noctua fans (but has not been tested with them) or any fans with 154mm hole spacing for mounting.

Constists of 5 parts: 4 plates, 1 connector.

Thickness of the the plate is 6mm (not mentioning the thickness at the point of connector which is another 6mm total).

Minimum requirements for mounting onto MO-RA 420:

• 4x 8mm M3 screws and nuts (to mount plates onto radiator itself)
• 4x 8mm M3 screws and nuts (to mount the connector)
• 4x 40mm M4 screws and nuts (for fans)
• or you can just hang the fans on any other length of the screws (worst case scenario)

Printing plates:

• PETG
• At least 210mm x 210mm x 12mm printing bed
• 4 wall loops
• 15% gyroid infill
• Total filament cost: 59.29g (one plate) x4

Printing connector:

• PETG
• 100% infill
• Total filament cost: 7.77g

Thanks and have a nice day.