This is a simple cartridge holder for 6 nintendo switch cartridges.

If the cartridge holder doesn't fit in the case after printing, try filing down the two bumps on the inside of the case. These are there to prevent the case from opening too easily, so try to keep just a little bit of them.

I designed this case to fit the cartridges a bit loosely, so that people with not as much experience regarding print settings could print this design without any major problems.

i'd love to see some remixes with a design on the outside, so if you've made any, please do make an "i made this" post.

Happy printing!

Anycubic Delta Plus

Doesn't Matter

Yes

0.2

20%

Infill doesn't really matter, because it gets printed pretty much solid anyways.

When you're done printing, clean up the inside of the cartridge holder as well as you can. This ensures that the cartridges can get in and out of the holder easily and without damaging them.

As i've already mentioned: If the cartridge holder doesn't fit in the case after printing, try filing down the two bumps on the inside of the case. These are there to prevent the case from opening too easily, so try to keep just a little bit of them.