This stand is perfect for playing Switch sitting at a desk, the ideal distance is about where your knees are.
I tried other models but they either didn't have cutouts (or enough clearance) for a charger cable or had too shallow of an angle, whereas this one sits at 45°

Separate models are included with a lower front retention wall for devices with a smaller bezel size, like the Switch OLED and Switch 2.

The model consists of two parts that slot into each other.
The mechanism was tested to fit snugly with a layer height of around 0.2-0.25mm.
For extra security, I used superglue between the halves.

When loading the models into your slicer, rotate them so the holes and pegs point upwards.
If your printer frequently experiences warping, consider printing with a brim.