Desktop phone stand fits a variety of devices and cases. Compatible with Loopy cases and with Popsockets or other fixtures attached to the back.

Prusa

i3 MK3

No

No

0.3 mm or finer

20

Prints clean with no supports required. Model will come into the slicer already oriented on it's side.

55g and 2:45 print time on Prusa I3 mark3 with 0.3mm layers.

To add grip pads using hot glue:

1) put a piece of aluminum foil or wax paper on a smooth, flat surface (like a marble counter top)
2) turn the print upside down
3) put equally sized drops of hot glue in each recessed hole, approximately twice the depth of the hole
4) set the stand on the foil or wax paper and let the glue cure
5) a couple of popsicle sticks or coins are useful to hold the base level while the glue is curing
6) peel the foil or paper off the glue pads and use your new stand