My wife wanted a stand to remove her MacBook Air from the desk and create more storage space underneath. This model had to be disassembled into 4 separate parts to fit on my build plate, but there are provisions to add structural strength when it's glued together. I printed the parts with the patterned side facing down and only needed to add small supports for two very thin parts.

This model was printed on my Creality K1C with MatterHackers Build Series PLA. I printed it at the standard K1C high speed, with the heating nozzle at 220 degrees Celsius, the bed at 60 degrees Celsius, and without a lid on the printer.