The holder is designed to hold a basic TQX Saber (https://superneox.com/en-de/products/jedi-artifact-lightsaber).
The saber holder is near universal.
The base fit in the pommel adapter, with an outer diameter of 33mm and fits snugly.

Both parts include a hole to fit up to 4,5mm coutersunk screw.
The recess on the wall side was ment to make it flush with the wall.
The print is intended to used Translucent PETG, the basic print settings where derived from the bambu lab forum (https://wiki.bambulab.com/en/knowledge-sharing/transparent-petg)