Sanlaki's Quest 2 VR non-dominant controller mount gave me a lot of wrist problems and that's likely because the non-dominant hand is mounted like the dominant hand as if there are two pistol grips but a foregrip or a handguard position is nothing at all like that.

This improved non-dominant hand mount is to allow a more natural foregrip at an ergonomic angle so the wrist doesn't feel any strain. It also has a second mount for handguard position.

I printed using support to support the handguard mount portion but I'm not sure if it's doable without, didn't try.

The print comes out slightly loose in the ring but I put in some electrical tape on the two ends and on the ring to protect any scratches on the controller which also helps to make it more snug. Use the same magnets as the one used in Sanlaki's design.

For non-dominant right-handed use, just mirror the print, there are no unnecessary words on this model file.

Remixed from: https://www.thingiverse.com/thing:4734013

Note: I'm not sure about other games but in onward the angle change of this controller mount means the position in game is higher than actual position of hand, which means the rifle angle will be off. As you can see from the images I'm currently designing a full gunstock that is highly adjustable including a front barrel that can be lowered to accurately align the rifle angle. Still working out the last few kinks in the design and will release another thing for the full gunstock.

Creality

Ender 3

No

Yes

200

20