The bottom of the case has a stand built into it to support the Controller at a 45º angle. You can use the bottom case with the top from Tig29's design.

The top of the case has removed the hole for the lcd backlight button. I did this because I found it easier to put a slide switch on the top of the case to toggle the light on and off. The toggle switch is connected to the jumper on the back of the Sainsmart board.

STOP lettering is debossed so you can run a fine point felt pen in the letters easily. Any overrun with the pen can be wiped off with isopropyl.

Link to Sainsmart LCD kit:

http://www.sainsmart.com/starter-kit/3d-printer-parts/sainsmart-smart-controller-ramps-1-4-lcd-12864-led-turn-on-control-for-3d-print-1.html

I printed the bottom of the case without supports, with a raft.