This is a slight modification to the hinges for the ikea lack enclosure from Prusa Research. I got tired of them always sliding out. This uses M4 x 12 mm screws and square nuts to secure the 3mm acrylic to the hinges. You'll need to purchase the screws and nuts, and drill the holes in the acrylic sheets (A regular drill set is fine. Use Eye Protection).

I supplied the hinges as an assembly along with support enforcers and blockers to place support on the bottom hinge where you need it. This is easy with prusaslicer, and I believe other slicers also allow you to do this as well. I included the .3mf file for easy printing from prusaslicer

Prusa

I3 MK3S

No

Yes

0.2

20%

I used PETG, you probably want something a little stronger than standard PLA