GoPro HERO5 frame latch

for GoPro HERO "The Frame" case. (I think it's for HERO 5/6/7)

my frame latch broke on me, and although there are some other frame/case latches here on Thingiverse, they are for earlier models, and the proportions are not correct for my model.

This doesn't try to replicate the full width of the original latch, as I don't think it would perform well due to lack of layer strength (if you are printing it standing up on end, which is probably best).

Print on end, with supports.

DISCLAIMER: this is provided as-is with no warranty. If your case pops open and the camera falls out and you lose all your cat surfing videos, it's not my fault.

Print Settings

Printer Brand:

PowerSpec

Printer:

Rafts:

No

Supports:

Resolution:

200

Infill:

Filament: Overture PETG Black

Category: Camera