I love Gloomhaven, however, I keep forgetting to choose the top portion of one card and the bottom portion of another card. I keep choosing two tops or two bottoms. By the time it is my turn, I forget which top and bottom I was using. I apparently cannot track two whole cards. So, I created these for me and my fellow travelers to use. Dimensions are XYZ 138.5x84x5mm

These .stl have 0 tolerance. You may have to adjust the top piece depending on your printer. My printer has a bit of elephant's feet so I use -0.1 for Initial Layer Horizontal Expansion.

I used Tinkercad to design this.

QIDI X-Maker

No

No

0.2 Layer

100%

Nozzle size: 0.4mm;
Line width: 0.35mm;
Wall width: 1.4 mm (4 lines);
Initial Layer nozzle temp: 190oC;
Nozzle temp: 200oC;

I snapped the pieces together to make sure they fit.
Then I glued them together with super glue.