We all probably have a few of those wireless charging pucks either just lying flat on a desk or in a drawer never to be used. So I wanted a stand to put it on so I could have my phone facing me instead of lying down; however all the designs out there were either for a specific shape of charger or phone. They also didn't look too pretty. Now I didn't look too hard so there very well may have been a design out there I liked but I didn't see it.

So I made this wireless charging puck mount that hold the puck and your phone as well as gives the cable a nice little route through the back to make it purty. I made the hole when you put the usb-c end through pretty tight so it helps keep the charger in place just in case you bump it but it should be able to accomadate some pretty beefy cords! I have a few pucks lying around of various circular sizes and they all seemed to fit pretty snugly in this design. 

100% infill for heavy weight at the bottom (anything over 20% works fine)

I printed in PETG just so I don't risk snapping the back off however I printed one in pla as well and it still seems alright

BONUS: Most of these pucks have rubber feet on the bottom that aren't needed now that it is mounted so go ahead and take the feet off and put them on the bottom of the mount.